Rear pin mounted hydraulic cylinders

A range of cylinders mounted on a simple pin hole to the rear, with a male threaded rod-end. These cylinders are made to order on short lead times and can be manufactured up to 5m stroke (customer to specify stroke length).

• Maximum working pressure 210 bar.
• Bore diameters available from 25mm to 250mm.
• Test pressure 300 bar unless otherwise stated.
• Can be used as Double-acting, Single-acting pull or Single-acting push.
• Cylinder material: ST52.3 DOM and CDS tube DIN2393 I.S.O. H8 & H9.
• Headbush material: Cast Iron - UNI5007–G25 unless otherwise stated.
• Rod material: Standard Grade EN8 DIN UNI CK45, Hard Chrome Plated, minimum 25 microns.

Additional / Alternative options,

• Fully upgradeable to marine specification.
• 350 bar Heavy Duty range of cylinders.
• Alternative rod and bore combinations available.
• Full range of alternative rod materials available, such as : NIKROM 500 View Spec sheet, Chrome plated Stainless Steel grades 431S29T / 316L / 304.
• Fully Stainless Steel options available.